Dryer Vent Installation in La Jolla, CA

Dryer vent routing problems specific to La Jolla

Coring stucco is the whole job here. Older Muirlands and Country Club houses carry stucco over wire mesh over wood lath. A hole saw walks on that mesh. You start outside, score the finish coat, then cut. Inside-out drilling blows the stucco face off in chunks. That chunk never patches invisibly.

Village and Shores cottages sit low. No floor cavity exists under the laundry area. The duct must go sideways through a wall into a side yard or alley. Setback distance to the neighbor's fence decides where the hood lands.

Salt exposure kills the hardware, not the duct. West-facing painted steel hoods chalk, then the damper hinge seizes. A seized-open damper lets marine layer moisture drift back down the pipe. Screens make it worse. Lint bridges a screen in weeks.

Check two things before calling anyone. Pull the dryer out and look at the transition hose for a crushed elbow behind the machine. Then stand at the exterior hood mid-cycle and feel the flap. Barely moving means the run, not the appliance.

Condos along Torrey Pines Road and the coast complicate this. That exterior wall belongs to the association. Their architectural committee controls penetration approval, and that timeline is theirs.